With the continuous advancement of technology, in recent years, various new types of Melt Blown Cloth Equipment have been continuously put into the mechanical equipment market. These new types of melt blown cloth equipment have great advantages in terms of production and processing speed and stability.
The new type of melt blown cloth equipment has stable performance, high working efficiency, and good energy saving and consumption reduction. Because of its performance advantages, it has been recognized by the market and consumers!
The whole line has reasonable structure and convenient operation. The entire production line has a high degree of automation. The control parts are all imported parts with reliable performance and stable operation. The equipment layout and width of the production line can be designed according to the user site and the width of the actual product.
It adopts a slotted barrel and a new High Quality Twin Screw Extrusion Line with higher screw speed, output and plasticizing capacity.
Advanced design, high output, good plasticization and low energy consumption. Using involute gear transmission, it has the characteristics of low noise, stable operation, large carrying capacity and long life.
In addition, there are a variety of electrical control systems to choose from, the production speed is fast, stable, and the control is simple and easy to operate. The production efficiency of the Meltblown Non-Woven Fabric Production Line is very high. The spunbonded non-woven fabric produced is evenly distributed, has good air permeability, is odorless, and meets relevant environmental protection requirements and standards.
Twin Screw Extrusion Line
1. Turn on the start-stop switch and the power switch, the built-in indicator light of the power switch lights up.
2. Adjust the air pressure: the air pressure valve is under the workbench. Open the door of the melt blown cloth equipment to view the air pressure valve. Adjust the pressure according to the actual situation. When certain mechanisms are not synchronized, increase the pressure. The working air pressure is generally adjusted within the range of 0.2~0.6MPa.
3. Sound wave inspection and adjustment:
①Turn on the power switch of the ultrasonic generator, and then press the "sonic test" switch. If the indicator of the amplitude indicator rises sharply and exceeds 100, it means that the frequency is too far away from the resonance point and the "sonic wave adjustment" knob must be adjusted. To check the amplitude display, press the switch of the sound wave check with your left hand, and then turn the sound wave adjustment knob with your right hand to adjust the pointer of the amplitude display to the lowest point.
When making adjustments, if the indication of the amplitude indicator is not falling but rising, please turn the "sonic adjustment" knob in the opposite direction. After adjusting the sound wave, tighten the wing nut and close the protective cover.
②During the no-load test, if the "overload indicator light" is on, it means that there is a problem with the melt blown cloth equipment. At this time, it is not allowed to start work, you must shut down and check the cause, and then start work after troubleshooting.
4. Check the cooling fan. Check whether the cooling fan is working properly to ensure that the melt blown cloth equipment can work for a long time during work.